NOT COMPATIBLE WITH BS (BiSecure) VERSION !!!
1. Self-learning remote control
2. Mainly apply to garage door, rolling curtain, etc.
3. Copy most 868,3Mhz fixed code remote controls
4. Learning face to face in few seconds
5. Battery included
Coding Mode: Fixed code
Frequency: Fixed frequency 868.3MHz
Battery Model: 27A
How to clone your remote control
program video link
Programming instructions in:
1)Click and Hold Lock and Unlock buttons together - Led will flash 3 times
2)Keep holding lock button and release unlock button ( keep holding Lock button since step 1 )
3)Push unlock button 3 times, Led will start flashing Non-stop. ( Keep holding lock button since step 1 )
4)Put both remotes Into back to Back position ( II ) ! Make sure they have direct contact , touching, push a bit to make them touch each other harder
5)Click and hold 1 button on your original remote and 1 button on your clone remote. Keep holding until led will make : 2 blinks > 3 blinks > Steady = Successfully cloned, only after the light goes into steady.
· After many tests remote control won't cloning, or cloning successful, but not operate the gates.
Can be few reasons:
1. Your original remote control battery is low power. (even if working fine)
Solution - Change new battery. (If you got multimeter check voltage. If voltage less than 1 Volt battery no good even if new. For example Battery must be 12V you got 11V)
2. Please make sure factory testing code is deleted, before start cloning.
If code clearance done properly, short press any button. Light won't flash at all.
If light flash when short press any button clearance process done wrong. Please repeat clearance process again.
3. When cloning led blink twice and no more.
868Mhz frequency remotes controls match harder clone, than any other frequency remote controls. Please be patient. Don't decide remote is faulty. All remotes deep tested before despatch and 100% working order.
You must find the best cloning position. In most cases the best position is back to back. But not always. On different models may be you need use other positions (face to face, side to side, like T position and etc.) Please watch video bellow. As you see on video first button clone ok, second button not (video time 0.22s) led blink twice and no more. Only when i moved remote down just a little cloned successfully